本產品是用於馬達換向器（已進行水洗磨合）的抗氧化劑。
以往，電機水洗磨合後，在乾燥過程中換向器表面容易形成氧化膜，這是常見問題。 Wet-Comm Sealer 無需等待馬達乾燥即可塗抹，從源頭防止氧化膜的形成。
*AQUA-PASS 技術：獨特的混合水溶性聚合物透過水分子迅速滲透到換向器表面。乾燥後，在換向器表面形成一層超薄保護膜。
使用方法
完成水中磨合（建議使用純淨水）後，將容器噴嘴插入馬達末端的鐘形孔，滴入一滴 Wet-Comm Sealer (WCS)，然後用手指旋轉馬達軸，使其均勻塗抹在換向器上。在室內乾燥約 8 小時。
本產品濃度設定基於馬達水洗磨合的前提。請勿將其塗抹於乾燥的馬達上。
WCS乾燥後，可以使用潤滑劑進行潤滑。切勿在乾燥前進行潤滑。
This is an antioxidant for commutators of motors that have undergone break-in in water.
Previously, the formation of an oxidized film on the commutator while the motor was drying after break-in in water was a problem. Wet-Comm Sealer can be applied without waiting for the motor to dry, preventing the formation of an oxidized film before it occurs.
*AQUA-PASS Technology: A uniquely blended water-soluble polymer instantly reaches the commutator surface via water molecules. After drying, it forms an ultra-thin barrier on the commutator.
How to Use
After completing the water break-in (purified water recommended), insert the container nozzle into the end bell hole of the motor, apply just one drop of Wet-Comm Sealer (WCS), then rotate the motor shaft with your finger to spread it evenly over the commutator. Let it dry indoors for about 8 hours.
The concentration is set on the premise of being used on wet motors. Do not apply it to dry motors.
After WCS has dried, lubrication with products is possible. Absolutely do not lubricate before drying.
